Nortel Networks 2300 Series Set mobility-domain member, Syntax set domain security none required

Mobility Domain Commands 229

Syntax set domain security {none required}

none	WSS-WSSsecurity is disabled.
required	WSS-WSSsecurity is enabled.

Defaults The default is none. (WSS-WSSsecurity is disabled.) Access Enabled.

History Introduced in WSS Software 5.0.

Usage The setting must be the same (none or required) on all switches, the seed and all members, in the Mobility Domain.

The set domain security none command is equivalent to the clear domain security command.

Examples The following command enables WSS-WSSsecurity on a WSS:

WSS# set domain security required

success: change accepted.

set mobility-domain member

On the seed WSS, adds a member to the list of Mobility Domain members. If the current WSS is not configured as a seed, this command is rejected.

Syntax set mobility-domain member ip-addrkey hex-bytes

ip-addr		IP address of the Mobility Domain member in dotted decimal notation.
key hex-bytes		Fingerprint of the public key to use for WSS-WSSsecurity. Specify the
		key as 16 hexadecimal bytes. Use a colon between each byte, as in the
		following example:
		00:11:22:33:44:55:66:77:88:99:aa:bb:cc:dd:ee:ff
Defaults	None.
Access	Enabled.
History
Version 5.0		Option key hex-bytesadded.

Usage This command must be entered from the seed WSS.

Examples The following commands add three WSSs with the IP addresses 192.168.1.8, 192.168.1.9, and 192.168.1.10 as members of a Mobility Domain whose seed is the current WSS:

WSS# set mobility-domain member 192.168.1.8 success: change accepted.

WSS# set mobility-domain member 192.168.1.9

Nortel WLAN—Security Switch 2300 Series Command Line Reference