Nortel Networks 2300 Series manual 802.1X Management Commands

505

802.1X Management Commands

Use 802. IEEE X management commands to modify the default settings for IEEE 802.1X sessions on a WSS. For best results, change the settings only if you are aware of a problem with the WSS’s 802.1X performance.

This chapter presents 802.1X commands alphabetically. Use the following table to locate commands in this chapter based on their use. For information about configuring 802.1X commands for user authentication, see Chapter , “AAA Commands,” on page 165.

Caution! 802.1X parameter settings are global for all SSIDs configured on the switch.

Wired Authentication Port	set dot1x port-control on page 502
Control	clear dot1x port-control on page 497
	set dot1x authcontrol on page 500
Keys	set dot1x key-tx on page 501
	set dot1x tx-period on page 506
	clear dot1x tx-period on page 499
	set dot1x wep-rekey on page 506
	set dot1x wep-rekey-period on page 507
Bonded Authentication	clear dot1x bonded-period on page 496
	set dot1x bonded-period on page 500
Reauthentication	set dot1x reauth on page 503
	set dot1x reauth-max on page 504
	clear dot1x reauth-max on page 497
	set dot1x reauth-period on page 504
	clear dot1x reauth-period on page 498
Retransmission	set dot1x max-req on page 501
	clear dot1x max-req on page 496
Quiet Period and Timeouts	set dot1x quiet-period on page 503
	clear dot1x quiet-period on page 497
	set dot1x timeout auth-server on page 505
	clear dot1x timeout auth-server on page 498

Nortel WLAN—Security Switch 2300 Series Command Line Reference