Nortel Networks 2300 Series manual Set ap radio tx-power

282AP Commands

Access Enabled.

History

Version 4.0	Option auto added for configuration of the AP configuration
	profile.
Version 6.0	Option dap removed.

Usage When you create a new profile, the radio parameters in the profile are set to their factory default values.

To enable or disable all radios that use a specific radio profile, use set radio-profile.

Examples The following command enables radio 1 on ports 5 through 8 assigned to radio profile rp1:

WSS# set ap 5-8 radio 1 radio-profile rp1 mode enable success: change accepted.

See Also

•clear ap image

•set ap radio mode on page 270

•set radio-profile mode on page 291

•show radio-profile on page 376

set ap radio tx-power

Sets an AP radio’s transmit power.

Syntax set {ap port-listap ap-num}radio {1 2} tx-power power-level

ap port-list	List of ports connected to the AP on which to set the transmit power.
ap ap-num	Number of a AP on which to set the transmit power.
radio 1	Radio 1 of the AP.
radio 2	Radio 2 of the AP. (This option does not apply to single-radio models.)

tx-powerpower-levelNumber of decibels in relation to 1 milliwatt (dBm). The valid values depend on the country of operation.

Note: The maximum transmit power you can configure on any Nortel radio is the maximum allowed for the country in which you plan to operate the radio or one of the following values if that value is less than the country maximum: on an 802.11a radio, 11 dBm for channel numbers less than or equal to 64, or 10 dBm for channel numbers greater than 64; on an 802.11b/g radio, 16 dBm for all valid channel numbers for 802.11b, or 14 dBm for all valid channel numbers for 802.11g.

Defaults The default transmit power on all AP radio types is the highest setting allowed for the country of operation or highest setting supported on the hardware, whichever is lower.

NN47250-100 (Version 02.51)