Nortel Networks 2300 Series manual Set service-profile wep key-index, Set service-profile wpa-ie

352AP Commands

set service-profile wep key-index

Sets the value of one of four static Wired-Equivalent Privacy (WEP) keys for static WEP encryption.

Syntax set service-profile name wep key-index num key value

name	Service profile name.
key-index num	WEP key index. You can enter a value from 1 through 4.
key value	Hexadecimal value of the key. You can enter a 10-character ASCII string
	representing a 5-byte hexadecimal number or a 26-character ASCII string
	representing a 13-byte hexadecimal number. You can use numbers or
	letters. ASCII characters in the following ranges are supported:
	•	0 to 9
	•	A to F
	•	a to f

Defaults By default, no static WEP keys are defined. Access Enabled.

History Introduced in WSS Software Version 3.0.

Usage WSS Software automatically enables static WEP when you define a WEP key. WSS Software continues to support dynamic WEP.

Examples The following command configures a 5-byte WEP key for key index 1 on service profile sp2 to aabbccddee:

WSS# set service-profile sp2 wep key-index 1 key aabbccddee

success: change accepted.

See Also

•set service-profile wep active-multicast-index on page 340

•set service-profile wep active-unicast-index on page 341

•show service-profile on page 380

set service-profile wpa-ie

Enables the WPA information element (IE) in wireless frames. The WPA IE advertises the WPA authentication methods and cipher suites supported by radios in the radio profile mapped to the service profile.

Syntax set service-profile name wpa-ie {enable disable}

name	Service profile name.
enable	Enables the WPA IE.
disable	Disables the WPA IE.

NN47250-100 (Version 02.51)