Nortel Networks 2300 Series manual Show mobility-domain config, Syntax show mobility-domain config

232Mobility Domain Commands

set mobility-domain mode secondary-seed domain- name seed-ip

Creates a Mobility Domain by setting the current WSS as the secondary seed device and naming the Mobility Domain.

Syntax set mobility-domain mode secondary-seed domain-name domain-nameseed-ip seed-

ip

mob-domain-nameName of the Mobility Domain. Specify between 1 and 32 characters with no spaces.

Defaults None.

Access Enabled.

History Introduced in WSS Software Version 6.0.

Usage Before you use this command, the current WSS must have its IP address set with the set system ip- address command. After you enter this command, all Mobility Domain traffic is sent and received from the specified IP address.

Examples Following is the example of secondary-seed domain-name seed-ip

WSS# set mobility-domain mode secondary-seed domain-name spl seed-ip 198.164.1.8

Success: change accepted.

show mobility-domain config

Displays the configuration of the Mobility Domain.

Syntax show mobility-domain config

Defaults None.

Access Enabled.

Examples The following command displays the Mobility Domain configuration:

WSS# show mobility-domain config

This WSS is a member, with seed 192.168.14.6

See Also

•clear mobility-domain on page 218

•set mobility-domain member on page 219

•show mobility-domain on page 222

show mobility-domain

On the seed WSS, displays the Mobility Domain status and members.

NN47250-100 (Version 02.51)