Nortel Networks 2300 Series manual Set port speed, WSS# set port poe 7,9 disable

Models: 2300 Series

1 622
Download 622 pages 48.74 Kb
Page 50
Image 50

50Port Commands

Defaults PoE is disabled on network and wired authentication ports. The state on AP ports depends on whether you enabled or disabled PoE when setting the port type. See set port type ap on page 41.

Access Enabled.

Usage This command does not apply to any gigabit Ethernet ports or to ports 7 and 8 on the 2360 and 2382 switch.

Examples The following command disables PoE on ports 7 and 9, which are connected to an AP:

WSS# set port poe 7,9 disable

If you are enabling power on these ports, they must be connected only to approved PoE devices with the correct wiring. Do you wish to continue? (y/n) [n]y

The following command enables PoE on ports 7 and 9:

WSS# set port poe 7,9 enable

If you are enabling power on these ports, they must be connected only to approved PoE devices with the correct wiring. Do you wish to continue? (y/n) [n]y

See Also

set port type ap on page 41

set port type wired-auth on page 44

set port speed

Changes the speed of a port.

Syntax set port speed port-list{10 100 1000 auto}

port-list

List of physical ports. WSS Software sets the port speed on all the

 

specified ports.

10

Sets the port speed of a 10/100 Ethernet port to 10 Mbps and sets the

 

operating mode to full-duplex.

100

Sets the port speed of a 10/100 Ethernet port to 100 Mbps and sets the

 

operating mode to full-duplex.

1000

Sets the port speed of a gigabit Ethernet port to 1000 Mbps and sets the

 

operating mode to full-duplex.

auto

Enables a port to detect the speed and operating mode of the traffic on the

 

link and set itself accordingly.

Defaults All ports are set to auto. Access Enabled.

Usage Nortel recommends that you do not configure the mode of a WSS port so that one side of the link is set to autonegotiation while the other side is set to full-duplex. Although WSS Software allows this configuration, it can result in slow throughput on the link. The slow throughput occurs because the side that is configured for autonegotiation falls back to half-duplex. A stream of large

NN47250-100 (Version 02.51)

Page 50
Image 50
Nortel Networks 2300 Series manual Set port speed, WSS# set port poe 7,9 disable, WSS# set port poe 7,9 enable