Nortel Networks 2300 Series AP Access Port Defaults, Version New values for model option added

Port Commands 53

Defaults All WSS ports are network ports by default.

Model AP-2330, AP-2330A, AP-2330B, and Series 2332 APs have two radios. On two-radio models, one radio is always 802.11a. The other radio is 802.11b/g, but can be configured for 802.11b or 802.11g exclusively. If the country of operation specified by the set system countrycode command does not allow 802.11g, the default is 802.11b.

Model AP-2330, AP-2330A, AP-2330B and Series 2332 APs have internal antennas but also have connectors for optional use of external antennas. (Antenna support on a specific model is limited to the antennas certified for use with that model.) To specify the antenna model, use the set {ap} radio antennatype command.

Access Enabled.

History

Version 4.1	New values for model option added:
	•	2330
	•	2330A
Version 5.0.11	New values for model option added:
	•	2330B
Version 6.0	New values for model option added:
	• 2332-A1, 2332-A2, 2332-A3, 2332-A4, 2332-
		A5, 2332-A6, 2332-E1, 2332-E2, 2332-E3,

2332-E4, 2332-E5, 2332-E6, 2332-E7, 2332-E8, 2332-E9, and 2332-J1.

Usage You cannot set a port’s type if the port is a member of a port VLAN. To remove a port from a VLAN, use the clear vlan command. To reset a port as a network port, use the clear port type command.

When you change port type, WSS Software applies default settings appropriate for the port type. Table 4 lists the default settings that WSS Software applies when you set a port’s type to ap.

Table 4: AP Access Port Defaults

Port Parameter	Setting
VLAN membership	Removed from all VLANs. You cannot assign an AP
	access port to a VLAN. WSS Software automatically
	assigns AP access ports to VLANs based on user traffic.
Spanning Tree Protocol (STP)	Not applicable
802.1X	Uses authentication parameters configured for users.
Port groups	Not applicable
IGMP snooping	Enabled as users are authenticated and join VLANs.
Maximum user sessions	Not applicable

This command does not apply to any gigabit Ethernet ports or to ports 7 and 8 on the 2360/2361 switch and port 3 on the 2382.

Nortel WLAN—Security Switch 2300 Series Command Line Reference