Port Commands 37

clear port type

Caution! When you clear a port, WSS Software ends user sessions that are using the port.

Removes all configuration settings from a port and resets the port as a network port.

Syntax clear port type port-list

port-list

List of physical ports. WSS Software resets and removes the

 

configuration from all the specified ports.

Defaults The cleared port becomes a network port but is not placed in any VLANs. Access Enabled.

Usage Use this command to change a port back to a network port. All configuration settings specific to the port type are removed. For example, if you clear an AP port, all AP-specific settings are removed. Table 1 lists the default network port settings that WSS Software applies when you clear a port’s type.

Table 1: Network Port Defaults

 

 

Port Parameter

Setting

 

 

VLAN membership

None.

 

Note: Although the command changes a port to a

 

network port, the command does not place the port in any

 

VLAN. To use the port in a VLAN, you must add the port

 

to the VLAN.

 

 

Spanning Tree Protocol (STP)

Based on the VLAN(s) you add the port to.

 

 

802.1X

No authorization.

 

 

Port groups

None.

 

 

Internet Group Management Protocol

Enabled as port is added to VLANs.

(IGMP) snooping

 

 

 

Access point and radio parameters

Not applicable

 

 

Maximum user sessions

Not applicable

 

 

Nortel WLAN—Security Switch 2300 Series Command Line Reference

Page 37
Image 37
Nortel Networks 2300 Series manual Clear port type, Network Port Defaults, Syntax clear port type port-list