Nortel Networks 2300 Series Set banner motd, 2360# set vlan 1 port 7 success change accepted

System Services Commands 69

1Configure a VLAN:

2360# set vlan 1 port 7 success: change accepted.

2Enable the DHCP client on VLAN 1:

WSS# set interface 1 ip dhcp-client enable success: change accepted.

3Enable the auto-config option:

WSS# set auto-config enable success: change accepted.

4Save the configuration changes:

WSS# save config

success: configuration saved.

See Also

• crypto generate key on page 472

• crypto generate self-signed on page 475

• save config on page 548

• set interface dhcp-client on page 110

• set vlan port on page 80

set banner motd

Configures the banner string that is displayed before the beginning of each login prompt for each CLI session on the WSS.

Syntax set banner motd ^text^

^	Delimiting character that begins and ends the message.
text	Up to 2000 alphanumeric characters, including tabs and carriage
	returns, but not the delimiting character (^). The maximum number
	of characters is approximately 24 lines by 80 characters.
Defaults	None.
Access	Enabled.

Usage Type a caret (^), then the message, then another caret.

Do not use the following characters with commands in which you set text to be displayed on the WSS, such as message- of-the-day (MOTD) banners:

•Ampersand (&)

•Angle brackets (< >)

•Double quotation marks (“”)

Nortel WLAN—Security Switch 2300 Series Command Line Reference