Software Maintenance | 41 |
7Depending on your TFTP server interface, click on the appropriate icon or button, to set the path for the application on your system.
Configuring the Router
1Enter the TFTP configuration status.
2Boot the router and press N immediately when Booting displays on the screen. The following information displays on the terminal interface:
(M)odify any of router configuration or (C)ontinue? [M]
3Press Enter. The following information displays:
For each of the following questions, you can press <Return> to select the value shown in braces, or you can Enter a new value.
NETWORK INTERFACE PARAMETERS:
Do you want a LAN interface? [N] y
This board's LAN IP address? [169.254.10.10]10.110.10.10 Subnet mask for LAN (0 for none)? [255.255.0.0]
TFTP SERVER PARAMETERS:
Configure the TFTP Server parameters, including IP address of the Ethernet interface on the PC, file name of the application program, CPU delay time and so on.
IP address of the TFTP server? [169.254.75.166]10.110.10.13
What is the name of the file to be loaded and started? [m8241ram.arj] How long (in seconds) should CPU delay before starting up? [5]
4Configure the network interface parameters for the router, including the interface to be used, its IP address, and subnet mask.
As you configure these parameters, set the values so that:
■The IP address of the TFTP server is the IP address of the PC connected to the Ethernet port on the router.
■The IP address and subnet mask are the same as the IP address and subnet mask of the LAN0 port.
■The IP addresses of the PC network interface and the LAN0 port of the router reside on the same segment.
After you enter the last parameter, the following information displays and you can verify that the parameters are set correctly.
NETWORK INTERFACE PARAMETERS:
IP address on LAN is 10.110.10.10
LAN interface's subnet mask is 0xffff0000
HARDWARE PARAMETERS:
Processor type is MPC8241
Internal Clock Rate 200 Mhz
External Clock Rate 100 Mhz
Serial channels will use a baud rate of 9600
TFTP SERVER PARAMETERS:
IP address of the TFTP host is 10.110.10.13
The file to download and start is m8241ram.arj
After board is reset,
(M)odify any of this or (C)ontinue? [M]C
5Enter C to confirm this configuration or M to modify any of the parameter settings.
