Nortel Networks 2300 Series manual Quit, Set enablepass, WSS quit, Syntax set enablepass

30Access Commands

See Also

•set enablepass on page 20

•set confirm on page 60

quit

Exit from the CLI session.

Syntax quit

Defaults None.

Access All.

Examples To end the administrator’s session, type the following command:

WSS> quit

set enablepass

Sets the password that provides enabled access (for configuration and monitoring) to the WSS.

Note. The enable password is case-sensitive.

Syntax set enablepass

Defaults None.

Access Enabled.

Usage After typing the set enablepass command, press Enter. If you are entering the first enable password on this WSS, press Enter at the Enter old password prompt. Otherwise, type the old password. Then type a password of up to 32 alphanumeric characters with no spaces, and reenter it at the Retype new password prompt.

Caution! Be sure to use a password that you will remember. If you lose the enable password, the only way to restore it causes the system to return to its default settings and wipes out the configuration.

Examples The following example illustrates the prompts that the system displays when the enable password is changed. The passwords you enter are not displayed.

WSS# set enablepass

Enter old password: old-password

Enter new password: new-password

Retype new password: new-password

Password changed

NN47250-100 (Version 02.51)