Nortel Networks 2300 Series manual Set port-group, See Also reset port on

Port Commands 45

The following command removes AP 1:

WSS# clear ap 1

This will clear specified AP devices. Would you like to continue? (y/n) [n]y

See Also

•clear ap on page 24

•clear port type on page 27

•set port type ap on page 41

•set system countrycode on page 63

set port

Administratively disables or reenables a port.

Syntax set port {enable disable} port-list

enable	Enables the specified ports.
disable	Disables the specified ports.
port-list	List of physical ports. WSS Software disables or reenables all the
	specified ports.

Defaults All ports are enabled. Access Enabled.

Usage A port that is administratively disabled cannot send or receive packets. This command does not affect the link state of the port.

Examples The following command disables port 16:

WSS# set port disable 16

success: set "disable" on port 16

The fol1owing command reenables the port:

WSS# set port enable 16

success: set "enable" on port 16

See Also reset port on page 32

set port-group

Configures a load-sharing port group. All ports in the group function as a single logical link.

Nortel WLAN—Security Switch 2300 Series Command Line Reference