Nortel Networks 2300 Series manual Show ap unconfigured, Syntax show ap unconfigured

384AP Commands

Table 20: Output for show ap global (continued)

Field	Description
WSS IP Address	System IP address of the WSS on which the AP is configured. A
	separate row of output is displayed for each WSS on which the
	AP is configured.
Bias	Bias of the WSS for the AP:
	•	High
	•	Low

See Also

•set ap on page 33

•set ap bias on page 249

•show ap config on page 344

•show ap connection on page 371

•show ap unconfigured on page 374

show ap unconfigured

Displays APs that are physically connected to the network but that are not configured on any WSSs.

Syntax show ap unconfigured

Defaults None.

Access Enabled.

Usage This command also displays an AP that is directly connected to a WSS, if the WSS port to which the AP is connected is configured as a network port instead of an AP access port, and if the network port is a member of a VLAN.

If a AP is configured on a WSS in another Mobility Domain, the AP can appear in the output until the AP is able to establish a connection with a WSS in its Mobility Domain. After the AP establishes a connection, the entry for the AP ages out and no longer appears in the command’s output.

Entries in the command output’s table age out after two minutes.

Examples The following command displays information for two APs that are not configured:

WSS# show ap unconfigured
Total number of entries: 2
Serial Id	Model	IP Address	Port	Vlan
-----------	---------	--------------- ---- --------
0333001287	AP-241 10.3.8.54		5	default
0333001285	AP-252 10.3.8.57		7	vlan-eng

Table 54 describes the fields in this display.

NN47250-100 (Version 02.51)