Nortel Networks 2300 Series manual Show ap arp, Syntax show ap arp ap-number, WSS# show ap arp

AP Commands 353

Defaults The WPA IE is disabled by default. Access Enabled.

History Introduced in WSS Software Version 3.0.

Usage When the WPA IE is enabled, the default authentication method is 802.1X. There is no default cipher suite. You must enable the cipher suites you want the radios to support.

Examples The following command enables the WPA IE in service profile sp2:

WSS# set service-profile sp2 wpa-ie enable

success: change accepted.

See Also

•set service-profileauth-dot1x on page 307

•set service-profileauth-psk on page 309

•set service-profilecipher-ccmp on page 312

•set service-profilecipher-tkip on page 313

•set service-profilecipher-wep104 on page 314

•set service-profilecipher-wep40 on page 315

•show service-profile on page 380

show ap arp

Displays the ARP table for a specified AP.

Syntax show ap arp ap-number

ap-numberIndex value that identifies the AP on the WSS switch.

Defaults None.

Access All.

History Introduced in WSS Version 6.0.

Examples The following command displays ARP entries for AP 7:

WSS# show ap arp 7

AP 7:

Host	HW Address	VLAN State	Type
---------	----------------------	------------- -------------
10.5.4.51	00:0b:0e:00:04:0c 1 EXPIRED		DYNAMIC

10.5.4.5300:0b:0e:02:76:f7 1 RESOLVED LOCAL

Table 39 describes the fields in this display.

Nortel WLAN—Security Switch 2300 Series Command Line Reference