Nortel Networks 2300 Series manual Clear ap local-switching vlan-profile, See Also set ap image on

248AP Commands

History
Version 5.0	Command introduced.
Version 6.0	Option dap removed.

Usage Use this command to configure an AP that had been converted to an AirDefense sensor to revert back to an AP. to load the software. When you do this, the next time the AP is booted, it becomes a Nortel Mobility Point.

Examples The following command causes the AirDefense sensor software file to be cleared from the configuration of AP 1:

WSS# clear ap 1 image

success: change accepted.

See Also set ap image on page 259

clear ap local-switching vlan-profile

Clears the VLAN profile that had been applied to an AP to use with local switching.

Syntax clear ap ap-numberlocal-switching vlan-profile

ap-number Index value that identifies the AP on the WSS switch.

Defaults None.

Access Enabled.

History Introduced in WSS Version 6.0.

Usage A VLAN profile consists of a list of VLANs and tags. When a VLAN profile is applied to an AP, traffic for the VLANs specified in the VLAN profile is locally switched by the AP instead of being tunneled back to an WSS.

Use this command to reset the VLAN profile used by the AP for local switching to the default VLAN profile. Traffic that had been locally switched because of an entry in the cleared VLAN profile is tunneled to an WSS.

When clearing a VLAN profile causes traffic that had been locally switched by APs to be tunneled to an WSS switch, the sessions of clients associated with the APs where the VLAN profile is applied are terminated, and the clients must re-associate with the APs.

Examples The following command clears the VLAN profile that had been applied to AP 7:

WSS# clear ap 7 local-switching vlan-profile

success: change accepted.

See Also

•set ap local-switching mode on page 260

NN47250-100 (Version 02.51)