Nortel Networks 2300 Series manual Set port name, WSS# set port 1 observer, Name name

48Port Commands

Examples The following command sets port 2 to monitor port 1’s traffic:

WSS# set port 1 observer 2

See Also

•clear port mirror on page 26

•show port mirror on page 49

set port name

Assigns a name to a port. After naming a port, you can use the port name or number in other CLI commands.

Syntax set port port name name

port	Number of a physical port. You can specify only one port.
name name	Alphanumeric string of up to 16 characters, with no spaces.
Defaults	None.

Access Enabled.

Usage To simplify configuration and avoid confusion between a port’s number and its name, Nortel recommends that you do not use numbers as port names.

Examples The following command sets the name of port 17 to adminpool:

WSS# set port 17 name adminpool

success: change accepted.

See Also

•clear port name on page 26

•show port status on page 51

NN47250-100 (Version 02.51)