Nortel Networks 2300 Series Set ap radio antenna-location, WSS# set ap 1 name techpubs, Indoors

272AP Commands

History
Version 4.1	Default AP name changed from DAPnum to DAPnum
Version 6.0	Option dap removed.

Examples The following command changes the name of the AP on port 1 to techpubs:

WSS# set ap 1 name techpubs

success: change accepted.

See Also show ap config on page 344

set ap radio antenna-location

Specifies the location (indoors or outdoors) of an external antenna. Use this command to ensure that the proper set of channels is available on the radio. In some cases, the set of valid channels for a radio differs depending on whether the antenna is located indoors or outdoors.

Syntax set {ap port-listap ap-num}antenna-location {indoors outdoors}

ap port-list	List of ports connected to the AP to rename.
ap ap-num	Number of a AP to rename.
indoors	Specifies that the external antenna is installed indoors (inside the
	building).
outdoors	Specifies that the external antenna is installed outdoors.

Defaults The default antenna location is indoor. Access Enabled.

History Introduced in WSS Software 5.0. Option dap removed in 6.0.

Examples The following command sets the antenna location for radio 1 on AP 22 to outdoor:

WSS# set ap 22 radio 1 antenna-location outdoor

success: change accepted.

NN47250-100 (Version 02.51)