Nortel Networks 2300 Series manual Set timedate, Mmm-month, Dd-day, Yyyy-year

152IP Services Commands

Access Enabled.

Usage You must use an address that is configured on one of the WSS’s VLANs.

To display the system IP address, use the show system command.

Examples The following commands configure an IP interface on VLAN taupe and configure the interface to be the system IP address:

WSS# set interface taupe ip 10.10.20.20/24

success: set ip address 10.10.20.20 netmask 255.255.255.0 on vlan taupe

WSS# set system ip-address 10.10.20.20

success: change accepted.

See Also

•clear system ip-address on page 106

•set interface on page 109

•show system on page 68

set timedate

Sets the time of day and date on the WSS.

Syntax set timedate {date mmm dd yyyy [time hh:mm:ss]}

date mmm dd yyyy		System date:
		•	mmm—month.
		•	dd—day.
		•	yyyy—year.
time hh:mm:ss		System time, in hours, minutes, and seconds.
Defaults	None.
Access	Enabled.

Usage The day of week is automatically calculated from the day you set. The time displayed by the CLI after you type the command might be slightly later than the time you enter due to the interval between when you press Enter and when the CLI reads and displays the new time and date.

Configure summertime before you set the time and date. Otherwise, summertime’s adjustment of the time will make the time incorrect, if the date is within the summertime period.

Examples The following command sets the date to March 13, 2003 and time to 11:11:12:

WSS# set timedate date feb 29 2004 time 23:58:00

Time now is: Sun Feb 29 2004, 23:58:02 PST

See Also

•clear summertime on page 105

NN47250-100 (Version 02.51)