Nortel Networks 2300 Series RF Detection Commands, Rogue Information Show rfdetect clients on

521

RF Detection Commands

WSS Software automatically performs RF detection scans on enabled and disabled radios to detect rogue access points. A rogue access point is a BSSID (MAC address associated with an SSID) that does not belong to a Nortel device and is not a member of the ignore list configured on the seed switch of the Mobility Domain.

WSS Software can issue countermeasures against rogue devices to prevent clients from being able to use them.

You can configure RF detection parameters on individual WSSs.

This chapter presents RF detection commands alphabetically. Use the following table to locate the commands in this chapter based on their use.

Rogue Information	show rfdetect clients on page 520
	show rfdetect mobility-domain on page 526
	show rfdetect data on page 524
	show rfdetect visible on page 531
	show rfdetect counters on page 523
Countermeasures	show rfdetect countermeasures on page 522
Permitted Vendor List	set rfdetect vendor-list on page 518
	show rfdetect vendor-list on page 531
	clear rfdetect vendor-list on page 514
Permitted SSID List	set rfdetect ssid-list on page 517
	show rfdetect ssid-list on page 530
	clear rfdetect ssid-list on page 513
Client Black List	set rfdetect black-list on page 515
	show rfdetect black-list on page 519
	clear rfdetect black-list on page 512
Attack List	set rfdetect attack-list on page 514
	show rfdetect attack-list on page 519
	clear rfdetect attack-list on page 512
Ignore List	set rfdetect ignore on page 515
	show rfdetect ignore on page 526
	clear rfdetect ignore on page 513
AP Signatures	set rfdetect signature on page 517
Log Messages	set rfdetect log on page 516
WSS-to-Client RF Link	rfping on page 533

Nortel WLAN—Security Switch 2300 Series Command Line Reference