Nortel Networks 2300 Series manual Set service-profile shared-key-auth

334AP Commands

Syntax set service-profile name rsn-ie {enable disable}

name	Service profile name.
enable	Enables the RSN IE.
disable	Disables the RSN IE.

Defaults The RSN IE is disabled by default. Access Enabled.

History Introduced in WSS Software Version 3.0.

Usage When the RSN IE is enabled, the default authentication method is 802.1X. There is no default cipher suite. You must enable the cipher suites you want the radios to support.

Examples The following command enables the RSN IE in service profile sprsn:

WSS# set service-profile sprsn rsn-ie enable

success: change accepted.

See Also

•set service-profileauth-dot1x on page 307

•set service-profileauth-psk on page 309

•set service-profilecipher-ccmp on page 312

•set service-profilecipher-wep104 on page 314

•set service-profilecipher-wep40 on page 315

•show service-profile on page 380

set service-profile shared-key-auth

Enables shared-key authentication, in a service profile.

Note. Use this command only if advised to do so by Nortel. This command does not enable preshared key (PSK) authentication for Wi-Fi Protected Access (WPA). To enable PSK encryption for WPA, use the set service-profileauth-pskcommand.

Syntax set service-profile name shared-key-auth {enable disable}

name	Service profile name.
enable	Enables shared-key authentication.
disable	Disables shared-key authentication.

NN47250-100 (Version 02.51)