Nortel Networks 2300 Series Configure succeed state indicates that the AP, Connections, Rogue

	AP Commands 373
	Table 13: Output for show ap status (continued)
Field	Description
Radio 1 type	802.11 type and configuration state of the radio.
Radio 2 type	• The configure succeed state indicates that the AP
	has received configuration parameters for the
	radio and the radio is ready to accept client
	connections.
	• 802.11b protect indicates that the 802.11b/g radio
	is sending messages to 802.11b devices, while
	sending 802.11g traffic at higher data rates, to
	inform the 802.11b devices about the 802.11g
	traffic and reserve bandwidth for the traffic.
	Protection mode remains in effect until 60
	seconds after the last 802.11b traffic is detected
	by the 802.11b/g radio.
	• Sweep Mode indicates that a disabled radio is
	nonetheless participating in rogue detection
	scans. Even though this message appears only for
	disabled radios, all radios, enabled or disabled,
	participate in rogue detection.
	• Countermeasures Enabled indicates that the radio
	is sending countermeasures packets to combat a
	rogue.
	• Radar Scan indicates that the radio is performing
	the initial channel availability check for Dynamic
	Frequency Selection (DFS). This state lasts
	during the first 60 seconds an 802.11a radio is on
	a new channel, during which time the radio does
	not transmit. If the radio does not detect any radar
	on the channel, the radio starts using the channel
	for data. If the radio does detect radar, the flag
	changes to Radar Detected. (See below).

Nortel WLAN—Security Switch 2300 Series Command Line Reference