System Log Commands 589

Examples The following command enables mark messages:

WSS# set log mark enable

success: change accepted.

See Also show log config on page 581

set log trace mbytes

This command is deprecated in WSS Software Version 4.0.

show log buffer

Displays system information stored in the nonvolatile log buffer or the trace buffer.

Syntax show log buffer [{+-}number-of-messages] [facility facility-name] [matching string] [severity severity-level]

buffer

Displays the log messages in nonvolatile storage.

+-number-of-messages

Displays the number of messages specified as follows:

 

• A positive number (for example, +100), displays

 

that number of log entries starting from the oldest

 

in the log.

 

• A negative number (for example, -100) displays

 

that number of log entries starting from newest in

 

the log.

facility facility-name

Area of WSS Software that is sending the log message. Type a

 

space and a question mark (?) after show log buffer facility for a

 

list of valid facilities.

matching string

Displays messages that match a string—for example, a username

 

or IP address.

Nortel WLAN—Security Switch 2300 Series Command Line Reference

Page 589
Image 589
Nortel Networks 2300 Series manual Set log trace mbytes, Show log buffer, See Also show log config on