4: Network Settings

Network 2 (wlan0) Interface Configuration

This page is used to configure the network 2 interface on the device. To see the effect of these items after a reboot, view the Status page.

 

Table 4-3 Network Interface Settings

 

 

Network Interface

Description

Settings

 

State

Click to enable or disable the WLAN interface.

 

 

DHCP Client

Click to enable or disable the DHCP client. If enabled, any configured IP

 

address, network mask, gateway or hostname will be ignored. DHCP will auto-

 

discover and eclipse those configured items. When DHCP fails to discover an

 

IP address, a new address will automaticaly be generated using AutoIP. This

 

address will be within the 169.254.x.x space. At boot up, after the physical

 

link is up, the xPico Wi-Fi will attempt to obtain IP settings from a DHCP server

 

and will periodically renew these settings with the server.

 

Note: Click renew on Interface Status page to force DHCP lease renewal.

 

 

IP Address

Enter the static IP address to use for the interface. You may enter it in one of

 

the following ways:

 

Alone (i.e., 192.168.1.1)

 

In CIDR format (i.e., 192.168.1.1/24)

 

With an explicit mask (i.e., 192.168.1.1 255.255.255.0)

 

Note: This setting will be used if Static IP is active (DHCP Client is Off).

 

 

Default Gateway

Enter the IP address of the router for this network.

 

Note: This setting will be used if Static IP is active (DHCP Client is Off).

 

 

Hostname

Enter the hostname for the interface. It must begin with a letter, continue with a

 

letter, number or hyphen, and must end with a letter or number. The device will

 

not register the hostname with a DNS server until the next reboot.

 

 

Primary DNS

Enter the IP address of the primary Domain Name Server.

 

Note: This setting will be used when Static IP is active.

 

 

Secondary DNS

Enter the IP address of the secondary Domain Name Server.

 

Note: This setting will be used when Static IP is active.

 

 

To Configure Network 2 Interface Settings

Using Web Manager

To modify network 2 WLAN interface information, click Network on the menu and select wlan0 > Interface > Configuration.

Using CLI

To enter the Interface command level: config -> Interface <instance>

xPico® Wi-Fi® Embedded Device Server User Guide

24

Page 24
Image 24
Lantronix 900-691-R manual Network 2 wlan0 Interface Configuration, To Configure Network 2 Interface Settings