Lantronix 900-691-R Configuration, Monitor Initialization Settings, Monitor Control Settings

11: Monitor

Configuration

Configure the monitoring of a connected serial device through specific configuration settings pages : Initialization, Control, Poll , Filter, and Data. Access the configuration options displayed in Table 11-2on the Initialization page. These configuration fields are the same ones in Step 1: Setup Initiation if utilizing Explorer.

	Table 11-2 Monitor Initialization Settings
Initialization	Description
Settings
Initial Delay	Set the initial delay time in milliseconds before the monitor starts processing the
	initialization message. This field also appears in Step 1: Setup Initiation.
Message <Number>	Click the Edit link to edit a specific message; this is where a command is entered.
	Four message fields will open to allow configuration of a specific command. When
Note: In other pages	you begin entering information in these fields, additional Message <Number>
	options become available containing the four message fields which will also open
(Commands/Control	upon clicking Edit. Complete the Message <Number> fields:
and Poll) in Explorer	 Command: enter the command in binary format (printable characters or binary
or under
	string)
Configuration,
	 End Character: indicate as a single printable character or as a control character.
additional Message
	Control characters may be input as <control>J, 0xA (hexadecimal) or \10
<Number> fields will
	(decimal).
become available to
	 Length: set the length of the response.
further filter and
	 Timeout: set the timeout length. Minimum timeout length is 100 milliseconds.
specify the information
you wish to monitor.	Click Submit after making changes to get real time response displayed if you are
	utilizing Explorer.

Access the configuration options displayed in Table 11-3on the Control page. These configuration fields are the same ones in Step 2: Setup Commands if utilizing Explorer.

	Table 11-3 Monitor Control Settings
Control Settings	Description
Message <Number>	Click the Edit link to edit a specific message; this is where a command is entered.
	Four message fields will open to allow configuration of a specific command. When
Note: In other pages	you begin entering information in these fields, additional Message <Number>
	options become available containing the four message fields which will also open
(Commands/Control	upon clicking Edit. Complete the Message <Number> fields:
and Poll) in Explorer	 Command: enter the command in binary format (printable characters or binary
or under
	string)
Configuration,
	 End Character: indicate as a single printable character or as a control character.
additional Message
	Control characters may be input as <control>J, 0xA (hexadecimal)
<Number> fields will
	or \10 (decimal).
become available to
	 Length: set the length of the response.
further filter and
specify the information	 Timeout: set the timeout length. Minimum timeout length is 100 milliseconds.
you wish to monitor.	Click Submit after making changes to get real time response displayed if you are
	utilizing Explorer.

xPico® Wi-Fi® Embedded Device Server User Guide 57