2:Introduction

This chapter summarizes the basic information and features of the xPico Wi-Fi embedded device server.

Key Features

Wireless LAN Interface:

-IEEE 802.11 b/g and IEEE 802.11n (single stream)

-WLAN interface (2.4 GHz only)

-IEEE 802.11 d/h/i/j/k/w/r

-IEEE 802.11i Support - WEP(Client only), WPA-Personal, WPA2-Personal

-u.FL connector for external antenna

-Soft Access Point with DHCP Server

-Simultaneous SoftAP and Client

-Roaming: continually tracks Wi-Fi signal strength within range, resulting in smooth and automatic transition between access points without delay.

-QuickConnect: Dynamic Profiles facilitate easy and rapid connections to access points

Host Interface:

-Serial Interface

Two Serial CMOS Ports 1200 to 921.6 Kbps Flow control: XON/XOFF, RTS/CTS (Line 1 only) Lantronix tunneling application

Modem Emulation Mode

-SPI Interface

Configurable slave/master SPI interface that can be clocked at 30MHz.

-USB Interface 2.0 (device)

USB2.0 (12 Mbps) Full Speed Device port interfaces for connection to an upstream USB device.

Support for USB CDC Serial profile (Future Release, contact Lantronix for more information).

-GPIO Interface

8 configurable general purpose Input/Output pins Custom pin manager

Network Protocols: TCP/IP, UDP/IP, DHCP Server (software-enabled Access Point interface), ARP, ICMP, DHCP Client (WLAN interface), Auto-IP, DNS, HTTP

Management and Control:

-Web Server

xPico® Wi-Fi® Embedded Device Server User Guide

13

Page 13
Image 13
Lantronix 900-691-R manual Introduction, Key Features