Lantronix 900-691-R manual To Configure Tunnel Accept Mode Settings

6: Tunnel Settings

Tunnel Accept Mode	Description
Settings (continued)
Flush Start Character	Enable or disable the flush start character:
	 Enabled = prevents forwarding of a start character from the Line into
	the network.
	 Disabled = the flush start character allows forwarding of a start
	character from the line into the network.
	Note: This configuration option becomes available when Start Character
	is the selected Mode.
Flush Line	Set whether the serial line data buffer is flushed upon a new network
	connection. Choices are:
	 Enabled = serial data buffer is flushed on network connection
	 Disabled = serial data buffer is not flushed on network connection
	(default)
Block Line	Set whether Block Line is enabled for debugging purposes. Choices are:
	 Enabled = if Enabled, incoming characters from the serial line will not
	be forwarded to the network. Instead, they will be buffered and will
	eventually flow off the serial line if hardware or software flow control is
	configured.
	 Disabled = this is the default setting; incoming characters from the
	Serial Line are sent into the network. Any buffered characters are sent
	first.
Block Network	Set whether Block Network is enabled for debugging purposes. Choices
	are:
	 Enabled = if Enabled, incoming characters from the network will not be
	forwarded to the Serial Line. Instead, they will be buffered and will
	eventually flow off the network side.
	 Disabled = this is the default setting; incoming characters from the
	network are sent on the Serial Line. Any buffered characters are sent
	first.
Password	Enter a password. This password can be up to 31 characters in length and
	must contain only alphanumeric characters and punctuation. When set,
	clients must send the correct password string to the unit within 30 seconds
	from opening network connection in order to enable data transmission.
	The password sent to the unit must be terminated with one of the following:
	 0A (Line Feed)
	 00 (Null)
	 0D 0A (Carriage Return/Line Feed)
	 0D 00 (Carriage Return/Null)
	If, Prompt for Password is set to Enabled and a password is provided,
	the user will be prompted for the password upon connection.

To Configure Tunnel Accept Mode Settings

Using Web Manager

To configure the Accept Mode for a specific tunnel, click Tunnel in the menu and select Tunnel 1 -> Accept.

Using CLI

 To enter the Tunnel command level: config -> Tunnel <instance>

xPico® Wi-Fi® Embedded Device Server User Guide 37