6:Tunnel Settings

The xPico Wi-Fi embedded device server has two lines available for tunneling.

Tunnel Settings

Tunneling allows serial devices to communicate over a network, without “being aware” of the devices which establish the network connection between them. Tunneling parameters are configured using the Tunnel menu and submenus. The Tunnel settings allow you to configure how the Serial-Network tunneling operates.

Note: The following section describes the steps to view and configure Line 1 settings; these steps apply to other line instances of the device.

Line Settings

These serial settings for the tunnel apply to the Serial Line interface. The Line Settings and Protocol are displayed for informational purposes and must be configured from the Line settings.

 

Table 6-1 Tunnel Line Settings

 

 

Tunnel Serial

Description

Settings

 

Line Settings

Line Settings information here is display only. Go to the section, To Configure

 

Line Settings to modify these settings.

 

 

Protocol

Protocol information here is display only. Go to the section, To Configure Line

 

Settings to modify these settings.

 

 

DTR

Select the DTR conditions in which Data Terminal Ready control signal on the

 

Serial Line is asserted.

 

Asserted while connected (Causes DTR to be asserted whenever either a

 

connect or an accept mode tunnel connection is active).

 

Continuously asserted

 

Unasserted

 

 

To View Tunnel Serial Settings

Using Web Manager

To view the Serial Settings for a specific tunnel, click Tunnel in the menu and select Tunnel 1 -> Line.

Using CLI

To enter the Tunnel command level: config -> Tunnel <instance>

Using XML

Include in your file: <configgroup name = "Tunnel Line" instance = "1">

xPico® Wi-Fi® Embedded Device Server User Guide

34

Page 34
Image 34
Lantronix 900-691-R manual Tunnel Settings, To View Tunnel Serial Settings, Tunnel Line Settings