Nortel Networks 2300 Series manual Set radio-profile auto-tune power-interval, Started

AP Commands 293

Syntax set radio-profile name auto-tune power-config {enable disable}

name	Radio profile name.
enable	Configures radios to dynamically set their power levels when the APs are
	started.
disable	Configures radios to use their statically assigned power levels, or the
	default power levels if unassigned, when the radios are started.

Defaults Dynamic power assignment is disabled by default. Access Enabled.

History Introduced in WSS Software Version 3.0.

Usage When RF Auto-Tuning for power is disabled, WSS Software does not dynamically set the power levels when radios are first enabled and also does not tune power during operation with associated clients.

When RF Auto-Tuning for power is enabled, WSS Software does not allow you to manually change the power level. Examples The following command enables dynamic power tuning for radios in the rp2 radio profile:

WSS# set radio-profile rp2 auto-tune power-config enable

success: change accepted.

See Also

•set ap radio auto-tunemax-power on page 265

•set radio-profileauto-tunechannel-config on page 279

•set radio-profileauto-tunepower-interval on page 283

•set radio-profileauto-tunepower-lockdown on page 284

•set radio-profileauto-tunepower-lockdown on page 284

•show radio-profile on page 376

set radio-profile auto-tune power-interval

Sets the interval at which RF Auto-Tuning decides whether to change the power level on radios in a radio profile. At the end of each interval, WSS Software processes the results of the RF scans performed during the previous interval, and changes radio power levels if needed.

Syntax set radio-profile name auto-tune power-interval seconds

name	Radio profile name.
seconds	Number of seconds WSS Software waits before changing radio power
	levels to adjust to RF changes, if needed. You can specify from 1 to 65535
	seconds.
Defaults The default power tuning interval is 300 seconds.
Access	Enabled.

Nortel WLAN—Security Switch 2300 Series Command Line Reference