Nortel Networks 2300 Series Set snoop mode, WSS# set snoop map snoop1 ap 3 radio, Filter-name all

Snoop Commands 579

filter-name	Name of the snoop filter.
ap ap-num	Number of a AP to which to map the snoop filter.
radio 1	Radio 1 of the AP.
radio 2	Radio 2 of the AP. (This option does not apply to single-radio models.)

Defaults Snoop filters are unmapped by default. Access Enabled.

History Introduced in WSS Software Version 4.0.

Usage You can map the same filter to more than one radio. You can map up to eight filters to the same radio. If more than one filter has the same observer, the AP sends only one copy of a packet that matches a filter to the observer. After the first match, the AP sends the packet and stops comparing the packet against other filters for the same observer.

If the filter does not have an observer, the AP still maintains a counter of the number of packets that match the

filter. (See show snoop stats on page 572.)

Examples The following command maps snoop filter snoop1 to radio 2 on AP 3:

WSS# set snoop map snoop1 ap 3 radio 2

success: change accepted.

See Also

•clear snoop map on page 566

•set snoop on page 567

•set snoop mode on page 569

•show snoop map on page 571

•show snoop stats on page 572

set snoop mode

Enables a snoop filter. A snoop filter does not take effect until you map it to an AP radio and enable the filter.

Examples set snoop {filter-nameall} mode {enable [stop-after num-pkts] disable}

filter-name all}

enable

[stop-after num-pkts]

Name of the snoop filter. Specify all to enable all snoop filters.

Enables the snoop filter.

The stop-afteroption disables the filter after the specified number of packets match the filter. Without the stop-afteroption, the filter operates until you disable it or until the AP is restarted.

disable Disables the snoop filter.

Nortel WLAN—Security Switch 2300 Series Command Line Reference