Amana ASD2328HEB Ice and Water, Troubleshooting, See Sabbath Mode page, See Dispenser Lock page

Troubleshooting

Ice and Water

PROBLEM	POSSIBLE CAUSES	WHAT TO DO
No indicator lights	Freezer door is not closed.	Verify that freezer door is closed. Power is removed
are lit on dispenser		from the control when freezer door is opened.
control	Refrigerator is not plugged in.	Plug in refrigerator.
	Fuse is blown, or circuit breaker needs to	Replace any blown fuses.
	be reset.	Check circuit breakers for any tripped circuits.
	Power outage has occurred.	Call local power company listing to report outage.
	Refrigerator is in Sabbath Mode.	See Sabbath Mode page 17.
Ice or water are	Freezer door is not closed.	Verify that freezer door is closed. Power is removed
not dispensed		from the control when freezer door is opened.
when pads are	Controls are in lock mode (select models).	See Dispenser Lock page 17.
pressed
	Water tank is filling.	At initial use, there is an approximate one- to two-
		minute delay in dispensing while the internal water
		tank is filling.
	Ice maker has just been installed or a	Wait 24 hours for ice production to begin or for ice
	large amount of ice has been used.	maker to restock after emptied.
	Water filter is clogged or needs to be	Change water filter (see page 18).
	changed.
Ice maker is not	Ice maker has just been installed or a	Wait 24 hours for ice production to begin or for ice
producing enough	large amount of ice has been used.	maker to restock after emptied.
ice or ice is	Water pressure is too low.	Low water pressure can cause valve to leak.
malformed
		Water pressure must be between 35 to 100 pounds
		per square inch to function properly. A minimum
		pressure of 35 pounds per square inch is
		recommended for refrigerators with water filters.
	Water filter is clogged or needs to be	Change water filter (see page 18).
	changed.
Ice maker is not	Ice maker arm is up.	Confirm ice maker arm is down. See Automatic Ice
producing ice		Maker page 15.
	Household water supply is not reaching	See Connecting the Water Supply pages 4 and 5.
	water valve.
	Copper tubing has kinks.	Turn off water supply and remove kinks.
		If kinks cannot be removed, replace tubing.
	Water pressure is too low.	Water pressure must be between 35 to 100 pounds
		per square inch to function properly.
		A minimum pressure of 35 pounds per square inch is
		recommended for refrigerators with water filters.
	Check freezer temperature.	See Temperature Controls pages 8 and 9 to adjust
		controls. Freezer must be between 0° to 2° F (-18° to
		-17° C) to produce ice.
	Ice bin is not installed properly.	See Ice Storage Bin page 13.
	Improper water valve was installed.	See Connecting the Water Supply pages 4 and 5.
		Self-piercing and 3⁄16" saddle valves cause low water
		pressure and may clog the line over time. The
		manufacturer is not responsible for property damage
		due to improper installation or water connection.
Water filter	Water filter needs to be replaced.	If filter is not available, replace with bypass filter.
indicator light is		See Water Filter page 18.
red	Filter indicator sensor needs to be reset.	See Filter Status Indicator Light page 17.
		continued…

31