Nortel Networks 2300 Series Set igmp qi, Set igmp qri, Syntax set igmp qi seconds vlan vlan-id

430IGMP Snooping Commands

Usage Proxy reporting reduces multicast overhead by sending only one membership report for a group to the multicast routers and discarding other membership reports for the same group. If you disable proxy reporting, the WSS sends all membership reports to the routers, including multiple reports for the same group.

Examples The following example disables proxy reporting on VLAN orange:

WSS# set igmp proxy-report disable vlan orange

success: change accepted.

See Also show igmp on page 423

set igmp qi

Changes the IGMP query interval timer on one VLAN or all VLANs on a WSS.

Syntax set igmp qi seconds [vlan vlan-id]

qi seconds	Number of seconds that elapse between general queries sent by the WSS
	when the switch is the querier for the subnet. You can specify a value
	from 1 through 65,535.
vlan vlan-id	VLAN name or number. If you do not specify a VLAN, the timer change
	applies to all VLANs.

Defaults The default query interval is 125 seconds. Access Enabled.

Usage The query interval is applicable only when the WSS is querier for the subnet. For the switch to become the querier, the pseudo-querier feature must be enabled on the switch and the switch must have the lowest IP address among all the devices eligible to become a querier. To enable the pseudo-querier feature, use the set igmp querier command.

Examples The following command changes the query interval on VLAN orange to 100 seconds:

WSS# set igmp qi 100 vlan orange

success: change accepted.

See Also

•set igmp lmqi on page 416

•set igmp oqi on page 418

•set igmp qri on page 420

•set igmp querier on page 421

•set igmp mrouter on page 417

•set igmp rv on page 422

set igmp qri

Changes the IGMP query response interval timer on one VLAN or all VLANs on a WSS.

NN47250-100 (Version 02.51)