Nortel Networks 2300 Series Set ip https server, Set ip route, WSS# set ip https server enable

126IP Services Commands

set ip https server

Enables the HTTPS server on a WSS. The HTTPS server is required for Web View access to the switch.

Caution! If you disable the HTTPS server, Web View access to the switch is disabled.

Syntax set ip https server {enable disable}

enable	Enables the HTTPS server.
disable	Disables the HTTPS server.

Defaults The HTTPS server is disabled by default.

Access Enabled.

Examples The following command enables the HTTPS server on a WSS:

WSS# set ip https server enable

success: change accepted.

See Also

•clear ip telnet on page 102

•set ip telnet on page 120

•set ip telnet server on page 120

•show ip https on page 152

•show ip telnet on page 155

set ip route

Adds a static route to the IP route table.

Syntax set ip route {default ip-addr mask ip-addr/mask-length}default-router metric

default	Default route. A WSS uses the default route if an explicit route
	is not available for the destination.
	Note: default is an alias for IP address 0.0.0.0/0.
ip-addr mask	IP address and subnet mask for the route destination, in dotted
	decimal notation (for example, 10.10.10.10 255.255.255.0).
ip-addr/mask-length	IP address and subnet mask length in CIDR format (for
	example, 10.10.10.10/24).

NN47250-100 (Version 02.51)