Note
•You can cancel Audyssey MultEQ® Room Correction and Speaker Setup at any point in this procedure simply by disconnecting the setup microphone.
•Do not connect or disconnect any speakers during Audyssey MultEQ Room Correction and Speaker Setup.
•If the AV receiver is muted, it will be unmuted automatically when Audyssey MultEQ Room Correction and Speaker Setup starts.
•Changes to the room after Audyssey MultEQ Room Correction and Speaker Setup requires you run Audyssey MultEQ Room Correction and Speaker Setup again, as room EQ characteristics may have changed.
Error Messages
While Audyssey MultEQ Room Correction and Speaker Setup is in progress, one of the error messages below may appear.
MultEQ: Auto Setup
AUDYSSEY
Ambient noise is too high.
Retry
Cancel
Error message
The options are:
`Retry:
Try again.
`Cancel:
Cancel Audyssey MultEQ Room Correction and Speaker Setup.
• Ambient noise is too high.
The background noise is too loud. Remove the source of the noise and try again.
• Speaker Matching Error!
The number of speakers detected was different from that of the first measurement. Check the speaker connection.
• Writing Error!
This message appears if saving fails. Try saving again. If this message appears after 2 or 3 attempts, contact your Onkyo dealer.
• Speaker Detect Error
This message appears if a speaker is not detected. “No” means that no speaker was detected.
Tip
•See “Speaker Configuration” for appropriate settings (➔ page 12).
En-26
Turning On & Basic Operations
The setup of the speaker can be done manually (➔ page 55).
The setup of the volume level of each speaker also can be done manually (➔ pages 56, 57).
Using a Powered Subwoofer
If you’re using a powered subwoofer and it outputs very
If the “Subwoofer” appears on the “Review Speaker Configuration” screen as “No”, increase the subwoofer’s volume to the