Explanatory Notes
a2. Speaker Setup
bSpeaker Configuration
c■ Subwoofer
d`Yes `No
aMain Menu
bSub Menu
cSetting target
dSetting options (default setting underlined)
Sub Menu
Main Menu
1. Input/Output Assign
Monitor Out
On the “Monitor Out” settings, you can select whether or not to have the video sources’ images output through the HDMI output.
If you connect your TV to HDMI output, “Monitor Out” setting is automatically set and composite video and component video sources are upconverted* and output.
Composite video, |
|
component video | HDMI |
| IN |
| OUT |
Composite video, | HDMI |
component video |
|
Note
•See “The video and audio signal flow” (➔ page 17) for charts showing how the “Monitor Out” and “Resolution” settings affect the video signal flow through the AV receiver.
■Monitor Out
`Main:
Select this if your TV is connected to HDMI OUT
MAIN.
`Sub:
Select this if your TV is connected to HDMI OUT
SUB.
`Both:
Select this if your TVs are connected to HDMI OUT MAIN and HDMI OUT SUB. Video signals are output from both HDMI outputs at the resolution supported by both TVs.
Advanced Operations
Note
•The “HDMI Through” setting is only available for the HDMI OUT MAIN jack (➔ page 65).
■Resolution
`Through:
Select this to pass video through the AV receiver at the same resolution and with no conversion.
`Auto:
Select this to have the AV receiver automatically convert video at resolutions supported by your TV.
`480p (480p/576p), 720p, 1080i, 1080p*1: Select the desired output resolution.
`4K:
Select this for an output resolution four times that of 1080p. Depending on the resolution supported by your TV, it will result in either 3840 × 2160 or 4096 × 2160 pixels.
You can specify the output resolution for HDMI OUT MAIN and have the AV receiver upconvert the picture resolution as necessary to match the resolution supported by your TV.
Tip
•You can see the picture by pressing ENTER to check the “Resolution” setting for HDMI OUT MAIN (excluding NET, USB and BLUETOOTH input source).
Note
•With some TVs, video signals are processed in the same way as “Through” when this setting is set to “4K”.
•If the “Monitor Out” setting is set to “Sub”, this setting is fixed to “Through”.
•If the “Monitor Out” setting is set to “Both”, this setting is fixed to “Auto”.
*1 When signal is 1080p input at 24 frames per second, it will be 1080p output at 24 frames per second.
En-53
Operating procedure (➔ page 52)