Connecting Onkyo RI Components
1 | Make sure that each Onkyo component is |
| connected with an analog audio cable |
| (connection H in the hookup examples) |
| (➔ page 15). |
2 | Make the uconnection (see the illustration). |
3 | If you’re using an RI Dock, or cassette tape |
| deck, change the Input Display (➔ page 46). |
With u(Remote Interactive), you can use the following special functions:
■System On/Auto Power On
When you start playback on a component connected via u, while the AV receiver is on standby, the AV receiver will automatically turn on and select that component as the input source.
■Direct Change
When playback is started on a component connected via u, the AV receiver automatically selects that
e.g., cassette tape deck
RI Dock
Note
R L ANALOG AUDIO OUT
R L ANALOG AUDIO OUT
Connections
Using Headphones
1 Connect a pair of stereo headphones with a standard plug (1/4 inch or ø 6.3 mm) to the PHONES jack.
While the headphones plug is inserted in the PHONES jack, =indicator lights.
Note
•Always turn down the volume before connecting your headphones.
•While the headphones plug is inserted in the PHONES jack, the speakers are turned off. (The Zone 2 speakers are not turned off.)
•When you connect a pair of headphones, the listening mode is set to Stereo, unless it’s already set to Stereo, Mono, Direct, or Pure Audio (European, Australian and Asian models).
component as the input source.
■Remote Control
You can use the AV receiver’s remote controller to control your other
(➔ page 72).
•Use only ucables for uconnections. ucables are supplied with Onkyo components.
•Some components have two ujacks. You can connect either one to the AV receiver. The other jack is for connecting additional
•Connect only Onkyo components to ujacks. Connecting other manufacturer’s components may cause a malfunction.
•Some components may not support all ufunctions. Refer to the manuals supplied with your Onkyo components.
•While Zone 2 is on, the System On/Auto Power On and Direct Change ufunctions do not work.
