AMX MVP-5200i manual Connection Status, Display Timeout, Inactivity Page Flip, Panel Brightness

Setup Pages

Setup Page (Cont.)

Connection Status:	Displays whether the panel is has external communication, as well as the
	encryption status of the Master, the connection type (Ethernet or USB), and to
	which System the panel is connected.
	• Until a connection is established, the message displayed is: “Attempting via
	Ethernet” or "Attempting via USB".
	• When a connection is established, the message displayed is either: “Connected
	via Ethernet “or “Connected via USB “.
	• The word “Encrypted” appears when an encrypted connection is established with
	a NetLinx Master.
	Note: The panel must be rebooted before incorporating any panel communication
	changes and to detect Ethernet connections.
Display Timeout:	Indicates the length of time that the panel can remain idle before activating Sleep
	mode, causing the device to power down.
	• Press the Up/Down buttons to increase/decrease the Display Timeout setting.
	Range = NONE, 10 sec., 15 sec., 20 sec., 25 sec., 30 sec., 5 mins., 15 mins., 30
	mins., 60 mins., 2 hrs.
	• Set the timeout value to NONE to disable Sleep mode.
	Note: Small timeout values maximize the life of the battery charge.
	Advanced Power Settings button: Enabling this button disables various peripherals
	that would otherwise remain powered while the device is in Sleep mode, including
	the navigation wheel. When this button is enabled, pressing the
	navigation wheel center will NOT wake up the panel, and only touching the touch
	screen will awaken it. This feature is only active when the device is running on
	battery power, and is not active when the device is on external power. When
	enabled, Advanced Power Savings allows additional battery life of panel availabil-
	ity without recharging.
	Disable Timeout On External Power button: When enabled, the display will not go
	into Timeout when external power is applied. The display always will go into the
	preselected Display Timeout setting when on battery power.
Inactivity Page Flip	Indicates the length of time that the panel can remain idle before automatically
Timeout:	flipping to a pre-selected page.
	• Press the Up/Down buttons to increase/decrease the Inactivity Page Flip
	Timeout setting. Range = 0 - 240 (minutes).
	• Set the timeout value to 0 to disable Inactivity Page Flip mode.
	Note: The touch panel page used for the Inactivity page flip is named within a
	small Inactivity Page field below the buttons.
Panel Brightness:	Sets the display brightness and contrast levels of the panel.
	• Press the Brightness Up/Down buttons to adjust the brightness level.
	Range = 0 - 100.
	NOTE: Be careful not to turn down the brightness too low to be able to see the
	Setup page.
Sleep Blink LED:	Enables and disables the blinking of the navigation wheel LED when the device is
	in Sleep mode. When enabled, the LED blinks while the device is charging. The
	Sleep Blink LED button is enabled by default.
	NOTE: This feature will only apply when the device is in Sleep mode. When the
	device is active, the state of the LED will match that of the display.

52 MVP-5200i Modero Viewpoint Widescreen Touch Panel