AMX MVP-5200i manual Installing the MVP-WCS-52, Installing the plastic Back Box

Accessories

Installing the MVP-WCS-52

Since the Wall Charging Station is intended to be affixed to a wall or other permanent structure, care must be taken to ensure its proper installation to prevent potential damage to the MVP-5200i placed within.

Other than wall installation tools, the only tool required for this installation is a #1

Phillips screwdriver.

Installing the plastic Back Box

The plastic back box has two knockouts at the top of the box and four (4) lockdown wings attached to the box with Phillips-head screws. For ease of installation, the interior of the box contains an "UP" arrow pointing to the knockouts. The Metal Rough-In Box does not have to be installed beforehand, but it offers an extra level of support.

To install the Plastic Back Box:

1.Cut a hole into the wall or surface intended to hold the box. The outer lip of the box is sized 8.69 inches (220.66mm) long and 6.0 inches (152.4mm) high, so the hole should be at least 1/4" (6.4mm) smaller in each dimension (FIG. 10).

8.25"

8.25"

(209.55mm)

(212.7mm

5.56"

5.56"

(141.29mm)

(141.29mm)

5.56"

5.56"

(141.29mm)

(141.29mm)

8.25"

8.25"

(209.55mm)

(212.7mm)

FIG. 10 Recommended cutout for plastic back box

Make sure to measure the size of the intended hole before starting to cut it.

2.Select the knockout to be removed from the top of the box. The box has two knockouts, at the top left and the top right.

14 MVP-5200i Modero Viewpoint Widescreen Touch Panel