AMX MVP-5200i manual Navigation Wheel behavior in each Power Mode, Power Mode Enters Mode By

Introduction

The light at the center of the navigation wheel brightens and dims based on its source of power. It lights at full intensity when attached to a power source, such as the Table Charging Station (see the Table Charging Station section on page 9) or the Wall Charging Station (see the Wall Charging Station section on page 11), but lights at only half intensity when running on its internal battery. This allows the user to ascertain whether the device was properly installed in a charging station, as the brightness will visibly increase with a correct docking and will flash while charging. (The flashing during recharging may be disabled via the device’s on-board Setup page, as explained in the Setup Pages section on page 51.) The behavior of the navigation wheel LED is dependent upon its status, and whether the blink function for the LED while in sleep mode is enabled:

Navigation Wheel behavior in each Power Mode

Power Mode	Power	Enters Mode By -	Exits Mode By -		LED Behavior		Notes
	Status				(Sleep Blink
					Setting)
					Enabled	Disabled
Awake (Full On)	Battery	N/A	N/A		ON	ON
	Power
Awake (Full On)	External	N/A	N/A		ON	ON
	Power
Awake (Full On)	Charging	N/A	N/A		BLINK	BLINK
Sleep (Display	Battery	1. Display TimeOut	1.Touch display		OFF	OFF	External
Off)	Power	setting reached	2.	Press			Power will
							transition
		2. Sleep Send	Navigation Wheel
							device to
		Command	3.	Press
							Display On
			Navigation Wheel
							Mode.
			center
			4.	Apply External
			Power
			5. WakeUp Send
			Command
Sleep (Display	External	1. Display TimeOut	1.	Touch display	OFF	OFF
Off)	Power	setting reached	2.	Press
		2. Sleep Send	Navigation Wheel
		Command	3.	Press
			Navigation Wheel
			center
			4.	Apply External
			Power
			5. WakeUp Send
			Command
Sleep (Display	Charging	1. Display TimeOut	1.	Touch Display	BLINK	OFF
Off)		setting reached	2.	Press
		2. Sleep Send	Navigation Wheel
		Command	3.	Press
			Navigation Wheel
			center
			4.	Apply External
			Power
			5. WakeUp Send
			Command

6 MVP-5200i Modero Viewpoint Widescreen Touch Panel