AMX MVP-5200i manual Configuring Communication

Configuring Communication

If the panel detects more than 10 WAPs, the Up/Down arrows at the far right side of the page become active (blue) and allow the user to scroll through the list of entries.

4.Select a desired Access Point by touching the corresponding row. The up arrow and down arrow will be grayed out if ten or fewer access points are detected. If more are detected, then they will be enabled as appropriate so that the user can scroll through the list.

5.With the desired WAP selected and highlighted, click the Connect button to be directed to the selected security mode’s Settings page with the SSID field filled in. From there, either Cancel the operation or fill in any necessary information fields and then click Save.

Selecting an Open, WEP, and WPA-PSK Access Point and then clicking Connect will open the corresponding Settings page. For any other security mode, clicking Connect will only return to the previous page without any information being entered.

In an Open security mode, after selection and connection to a target WAP, the SSID name of the selected WAP is saved for the open security mode.

In a Static WEP security mode, after selection and connection to a WEP Access Point, the user is then redirected back to the Static WEP security screen, where the SSID field is already filled out. The user is only required to enter in the remaining WEP key settings.

A similar process occurs for WPA-PSKaccess points. For any other situation, the security mode switches back to the previous page and security and connection parameters must be entered in as usual.

28 MVP-5200i Modero Viewpoint Widescreen Touch Panel