AMX MVP-5200i manual All lockdown wings folded flat during installation

Accessories

To assist with wiring, and to avoid mechanical stresses on the wire and the mechanism of the Wall-Mounted Charging Station, the top right knockout is preferred for use.

3.Run the power cable through the knockout into the box. Pull out about six inches (15.25cm) of cable into the box to facilitate installation of the MVP-WCS-52.

4.Slide the plastic back box into the hole, being careful not to twist or pinch the cable, and set it flush with the wall (FIG. 11). Make sure that all of the lockdown wings are folded into their slots before attempting to insert the box. For ease of installation, the inside of the box has the direction "UP" labeled for reference.

All lockdown wings folded flat during installation

Note Orientation Designator

FIG. 11 Installation of plastic back box

5.Extend the wings on the sides of the box by tightening the screws inside the box. Not all of the wings must be extended to lock the box in place, but extending a minimum of the top and bottom wings is highly recommended. Apply enough pressure to the screw head to keep the box flush with the wall: this ensures that the wing will tighten up against the inside of the wall.

Make absolutely certain that the box is in its intended position. Once the box lockdown wings are extended within the box’s hole within the wall, removing the box will be extremely difficult without damaging the wall in the process.

The maximum recommended torque to screw in the wings on the plastic back box is 105 IN-OZ [74 N-CM]. Applying excessive torque while tightening the wing screws, such as with powered screwdrivers, can strip out the wings or damage the plastic back box.

6.Prepare the captive wires for the 2-pin 3.55 mm mini-captive wire connector used for the MVP- WCS-52’s power supply:

Preparing and connecting the captive wires requires the use of a wire stripper and flat-blade screwdriver.

MVP-5200i Modero Viewpoint Widescreen Touch Panel 15