AMX MVP-5200i manual Configure the Card’s Wireless Security Settings

Configuring Communication

Step 2: Configure the Card’s Wireless Security Settings

The second step in setting up the wireless card is to configure the Wireless Settings section of the Wireless Settings page. This section configures both the communication and security parameters from the internal wireless card to the WAP. The procedures outlined within the following sections for an

802.11g card facilitate a common security configuration to a target WAP.

Refer to the Appendix B: Wireless Technology section on page 166 for more information on other security methods.

After setting up the wireless card parameters, configure the communication parameters for the target Master; see Step 3: Choose a Master Connection Mode section on page 35.

Configuring the device’s wireless card for unsecured access to a WEP

In the Protected Setup page:

1.Press the Wireless Settings button (located on the lower-left) to open the Wireless Settings page (FIG. 21).

MVP connection IP info

Wireless card security settings

FIG. 21 Wireless Settings page (showing a sample unsecured configuration)

2.Enter the SSID information by:

Automatically filling it by pressing the Site Survey button. From the Site Survey page, choosing an Open WAP from within the Site Survey page and then pressing the Connect button at the bottom of the page (FIG. 22).

Select an OPEN

(unsecured) WAP

Connecting to the WAP begins the communication.

FIG. 22 Site Survey of available WAPS (Unsecured WAP shown selected)

Manually entering the SSID information into the appropriate fields by following steps 7 through 9.

MVP-5200i Modero Viewpoint Widescreen Touch Panel 29