Introduction

Navigation Wheel behavior in each Power Mode (Cont.)

Power Mode

Power

Enters Mode By -

Exits Mode By -

LED Behavior

Notes

 

Status

 

 

(Sleep Blink

 

 

 

 

 

Setting)

 

 

 

 

 

Enabled

Disabled

 

 

 

 

 

 

 

 

Stand By

Battery

Enabled Advanced

1. Apply External

Off

OFF

External

(Display Off,

Power

Power Management

Power

 

 

Power will

Electronics

 

1. Display TimeOut

2. Touch Display

 

 

transition

halted)

 

 

 

unit to

 

setting reached

3. WakeUp Send

 

 

 

 

 

 

Sleep Mode

 

 

 

 

 

 

 

2. Sleep Send

Command

 

 

 

 

 

 

in < 10

 

 

Command

 

 

 

 

 

 

 

 

seconds.

 

 

 

 

 

 

 

 

 

 

 

 

 

Stand By

External

N/A

Same as Sleep

OFF

OFF

 

(Display Off,

Power

 

Mode

 

 

 

Electronics

 

 

 

 

 

 

halted)

 

 

 

 

 

 

 

 

 

 

 

 

 

Stand By

Charging

N/A

Same as Sleep

OFF

OFF

 

(Display Off,

 

 

Mode

 

 

 

Electronics

 

 

 

 

 

 

halted)

 

 

 

 

 

 

 

 

 

 

 

 

 

Shut Down (Off)

Battery

1. Panel Shutdown

1. Apply External

OFF

OFF

External

 

Power

setting reached

Power

 

 

Power will

 

 

2. Panel Shutdown

2. Press and hold

 

 

transition

 

 

 

 

unit to

 

 

button pressed

Navigation Wheel

 

 

 

 

 

 

Awake

 

 

3. Navigation Wheel

button

 

 

 

 

 

 

Mode after

 

 

button held

 

 

 

 

 

 

 

 

boot up

 

 

 

 

 

 

 

 

 

 

 

 

 

Shut Down (Off)

External

N/A

Same as Sleep

OFF

OFF

 

 

Power

 

Mode

 

 

 

 

 

 

 

 

 

 

Shut Down (Off)

Charging

N/A

Same as Sleep

OFF

OFF

 

 

 

 

Mode

 

 

 

 

 

 

 

 

 

 

The navigation wheel may also be programmed to initiate specific commands. For more information, please see the Programming section on page 103.

Intercom Microphone

The MVP-5200i contains a built-in microphone above the upper lefthand corner of the touch screen for video and audio conferencing capabilities. This microphone is concealed by the casing.

Stylus

The MVP-5200i comes with a unique touchscreen stylus that slides into a storage groove on the right side of the device when not in use. Replacement styluses may be ordered in a 3-pack (FG5966-30-xx) from www.amx.com.

Kick Stand

Since the MVP-5200i device is designed to be a unit used away from its charging station, it has an extendable "kickstand" on the back of the unit (FIG. 2). This may be opened by physically lifting the free end of the kick stand away from the device. The device may then be propped up on a flat surface and accessed in a normal fashion.

MVP-5200i Modero Viewpoint Widescreen Touch Panel

7

 

 

Page 15
Image 15
AMX MVP-5200i manual Intercom Microphone, Stylus Kick Stand, LED Behavior Status Sleep Blink Setting Enabled Disabled