AMX MVP-5200i manual Tie-Wrap Anchors Mini-Captive Wire Connector Plug female

Accessories

Strip 0.25 inch (6.35 mm) of wire insulation off all wires.

Insert each wire into the appropriate opening on the connector.

Turn the screws clockwise to secure the wires in the connector. Do not over-torque the screws; doing so can bend the seating pins and damage the connector.

7.Secure the power cable to the device, using either of the two tie-wrap anchors included in the Installation Kit at the top rear of the device (FIG. 12). Point the head of each tie wrap toward the center of the device.

Tie-Wrap Anchors

Mini-Captive Wire Connector Plug (female)

FIG. 12 MVP- WCS-52 - Rear

8.Firmly seat the mini-captive wire connector to the power connector on the device.

9.Firmly seat the device against the box. Make sure that the tab connector at the top of the device is locked into the box.

10.Insert the two installation screws from the MVP-WCS-52 Installation Kit into the screw holes in the interior compartment of the device and tighten them to anchor the device to the box (FIG. 13).

16 MVP-5200i Modero Viewpoint Widescreen Touch Panel