Accessories

4.Place the touch panel in the Charging Station cradle (FIG. 6), guiding it into place with the locking grooves on each side of the cradle (FIG. 7). When fully seated, the touch panel’s charging station connector should be in contact with the Charging Station’s charger pins.

MVP-5200i device

Table Charging

Charging station Station rear support

FIG. 6 MVP-5200i in MVP-TCS-52-GB Table Charging Station

Connections and Wiring

The PS3.0 is used to supply power to the MVP-5200i by routing incoming power through the connector pins and charge the device’s internal battery

Recharging

To recharge the MVP-5200i, slide the device into the Table Charging Station cradle bottom-first and make sure the device is fully seated in the Charging Station. The charger pins in the bottom of the cradle (FIG. 7) must be in contact with the connector on the bottom of the MVP-5200i for it to start recharging. The MVP panel will stop recharging automatically once the battery has achieved its maximum charge.

Charging Station cradle

Charger pins

FIG. 7 MVP-TCS-52-GW Table Charging Station - Rear

Cleaning the MVP-TCS-52

You should clean the Table Charging Station after each day’s use to maintain the device’s appearance. Always use a clean cotton cloth and a spray bottle containing water or a vinegar-based cleaner, as alcohol-based cleaners can damage the device. Do not directly spray the device: instead, spray the cloth to prevent moisture from collecting on the charger pins. Do NOT use an abrasive of any type to clean the Table Charging Station, as this may permanently damage or remove the device’s finish.

10

MVP-5200i Modero Viewpoint Widescreen Touch Panel

Page 18
Image 18
AMX MVP-5200i manual Connections and Wiring, Recharging, Cleaning the MVP-TCS-52