Honeywell K9696V2 2.3Reporting the Installation, 2.4Powering the Multi-MediaUnit, Flexibility

Multi-Media Unit: Installation Instructions

2.3Reporting the Installation

Flexibility

As you start connecting, hardware to the Multi-Media unit, Honeywell recommends that installers take notes in a form similar to the one provided in 7.5: Site Information, on

p. 7–8. Include a record of the hardware connected to the Multi-Media unit and of use of LocalView to make changes to the Rapid Eye site’s configuration.

To whom...

Direct the report to the:

•Multi SA. An organization’s Multi system administrator (Multi SA), responsible for use of the Admin software.

-and/or -

•network administrator. The installer may need to contact the organization’s network administrator, depending on a Multi system’s sensitivity, complexity, size, and the Multi SA’s knowledge of computers and networks.

Content of installation report

The report contains information needed for configuring the site(s) using Admin and View software.

The installation report can list:

•telephone number or IP addresses assigned to Rapid Eye sites

•information about the cameras (color, PTZ, and so on)

•use of other hardware (gates, alarms and so on) connected to the Multi-Media unit’s input(s) or output(s).

2.4Powering the Multi-Media Unit

Power requirement

A Multi-Media unit can auto-range:

•100–240 V~, 63–47 Hz, 6–3 A

For many cameras in a permanent installation, you can use a power supply such as an APS 2404UL (4 cameras) or APS 2416UL (16 cameras).

Uninterruptible power supply

To allow time for a safe power-down, a UPS should guarantee 300 watts of power for each Multi-Media unit, for at least 30 minutes.

In Europe, a UPS is required to meet EN50130–4.

2–4