Multi-Media Unit: Installation Instructions

Table 14

Sensor hardware

 

Acronym

Sensor Input

Implication

 

 

NO

Normally Open

input is active when switch goes ON

 

 

NC

Normally Closed

input is active when switch goes OFF

 

 

EOL

End of Line

input is active when switch goes ON, or if

 

 

 

 

wires to the alarm sensor are cut

 

 

 

 

 

 

 

 

 

 

 

5.7Control Outputs

Purpose

A View operator can activate outputs.

Up to 24 mA can be drawn at each output.

Cable

Use hookup wire in the 20-gauge range to connect the outputs to relay triggered devices (locks, gates, warning sirens and so on) to a Multi-Media unit.

Tools

You may need:

a slot screwdriver—supplied. The screws are slightly smaller than those for a 1/8" screwdriver.

a wire stripper.

Connector

1.From the hookup wires’ tips, strip approximately 0.6 cm (1/4 inch) of insulation.

2.Insert each relay control wire to the screw-type, terminal connector on the CONTROL OUTPUTS terminal strip: one wire to ground and the other wire to the numbered connection you choose.

To avoid short-circuits, ensure that bare wire is not visible at the rear panel.

5.8System Monitoring

Fault relay

A Multi-Media unit can be monitored for failure:

to function

to report alarms

Should such a failure last more than 19 minutes, the FAULT RELAY is triggered.

5–8

Page 66
Image 66
Honeywell K9696V2 installation instructions Control Outputs, System Monitoring

K9696V2 specifications

The Honeywell K9696V2 is a state-of-the-art temperature control device designed for versatile applications in various heating and cooling systems. This advanced controller is known for its precision, reliability, and user-friendly interface, making it an essential component for modern HVAC setups.

One of the main features of the K9696V2 is its ability to support multiple control strategies. It can effectively manage single-stage and multi-stage heating and cooling systems, allowing it to be used in a wide range of residential and commercial applications. This flexibility ensures that users can easily integrate the controller into existing setups without significant modifications.

The K9696V2 incorporates advanced technologies such as microprocessor-based control. This ensures precise temperature management, enhancing comfort while minimizing energy consumption. It features a built-in temperature sensor that provides accurate readings, ensuring that the system operates within the desired range. Users can set temperature thresholds that the controller will maintain, making it ideal for environments where temperature stability is critical.

Another notable characteristic of the Honeywell K9696V2 is its user-friendly interface. The device is equipped with an intuitive digital display that provides real-time temperature readings and system status. Additionally, users can easily navigate through the menu to adjust settings without the need for complicated configurations, which is a significant advantage for both technicians and end-users.

The K9696V2 also offers robust communication capabilities. With support for various communication protocols, including Modbus and BACnet, the device can integrate seamlessly with building management systems. This connectivity allows for remote monitoring and control, giving facility managers greater oversight of their HVAC operations.

Finally, the Honeywell K9696V2 is designed with energy efficiency in mind. By optimizing system performance and providing precise control, this controller helps to reduce energy consumption, translating to cost savings for users. Its durable build ensures longevity, making it a worthy investment for those seeking reliable temperature control solutions.

Overall, the Honeywell K9696V2 stands out in the market due to its advanced features, adaptability, and user-centric design, making it a preferred choice for temperature control in a variety of settings.