Honeywell K9696V2 2.7Network Connection, To change a LocalView password, Very low recording rates

Field Work

!18 To change a LocalView password

1.After locking a LocalView function, as explained in procedure !17, click that function’s Password button. A window appears showing a virtual keypad.

2.Using the virtual keypad, enter a number. The password's length can be between 4 and 10 digits.

3.Click OK.

Please make a note of passwords. A lost password can make the LocalView interface unchangeable.

Default LocalView passwords

To lock a Cycle: 1111.

To lock the LocalView setup: 9999; this password can be used to also unlock a cycle of the Live tabs.

To lock the availability of making a clip: 1111.

The LocalView passwords have no effect on other passwords, set using Admin software. See the Admin User Guide for procedures involving other passwords.

Very low recording rates

Table 5 shows some limits that a Multi SA needs to impose on cycle times for low

recording rates only when using LocalView.

Table 5

Restriction for LocalView cycle times when setting low recording rates

recording rate (fps) lowest cycle time (sec.)

0.2516

0.58

1.04

2.7Network Connection

Overview

You may not need to assign an IP address to a unit if your network is enabled for Dynamic Host Configuration Protocol (DHCP).

Networks with DHCP

Multi-Media units can be enabled as DHCP clients; DHCP is OFF by default. After enabling DHCP, power-down a unit connected to the network and power-up. See the

Admin User Guide for detailed procedures.

A network administrator has the option of assigning a reserved IP address to a Multi- Media unit, instead of a “computer name”. In that case, the unit’s default IP address can be used. You have the option of assigning a different static IP address to the unit using the procedures for networks without DHCP, below.

2–9