Honeywell K9696V2 2.8Dial-upConnection, the Multi-MediaUnit, on p. 2–4, Field Work, What next?

Field Work

After 10 minutes of inactivity, the Multi-Media Shell times out.

To return to it, turn the Multi-Media unit off, then use procedure 22.

!25 To return to the Multi-Media Shell after a time out

•Turn the Multi-Media unit off, wait five seconds, then turn the unit on again and go back to the previous procedures.

The commands for the Multi-Media Shell are listed above in the Multi Shell Reference, on the next page.

2.8Dial-up Connection

For Telco communication, a data-grade (fax) telephone line is preferable to a standard line. Special features, such as call waiting, should not be available to a telephone line used by a Multi-Media unit.

Fig. 20. Detail of “TELCO” port, used for dial-up connection.

Honeywell recommends powering down a unit before connecting hardware to it. See 2.4.1: Powering Up and Down, p. 2–5.

!26 To connect the Multi-Media unit to a telephone line jack

1.Using a standard telephone cable with RJ-11 connectors, plug one connector into the unit’s TELCO port; see figure 20.

2.Plug the other connector in a telephone outlet.

Connect the unit to a telephone line only if a dial-up connection is used to communicate with the Multi-Media unit. For a network connection, please skip to section 2.7: Network Connection.

What next?

You are ready to power-up the camera(s) and unit as explained in section 2.4: Powering

the Multi-Media Unit, on p. 2–4.

2–15