Omron Healthcare NE-U17 How to Disinfect and Store the Unit, Sterilization by autoclave

How to Disinfect and Store the Unit

Sterilization with ethylene oxide gas (E.O.G.)

Observe the Instruction Manual of the sterilizer and consult with the manufacturer of the E.O.G. sterilizer for the details.

Some of the rubber and plastic parts of the nebuliser may have residual ethylene oxide gas. After sterilization, consult with the manufacturer of the sterilizer and provide sufficient aeration until the safe level to human beings can be obtained.

The equipment and the parts to be sterilized by E.O.G. must be sufficiently dried in advance. Wash and dry the parts, then conduct the E.O.G. sterilization.

Sterilization by autoclave

Refer to the Instruction Manual and the Notes on Handling of the sterilizer.

[Option parts that can be sterilized by autoclave]

Inhalation mask (L)	Inhalation mask (S)
(4997205-3)	(4997207-0)

Caution

When parts are sterilised in an autoclave, make sure these parts do not directly contact the heater inside the autoclave.

* As the temperature of the heater is very high, these parts may be melted or deformed.

How to store the unit

Store the parts after thoroughly drying them.

When storing the parts, be careful for the infection.
Do not store the unit under direct sunlight, where
temperature and humidity are high, in a dusty place, where
they can be easily sprayed with water, or where vibration or
shock can be easily applied.	EN

18