Lantronix 900-510 Access, Outlets Enable for, Dial-back, Escape, Sequence, Break, Custom Menu

	11: User Authentication
Access	The outlets the user may monitor and configure.
Outlets
Enable for	Select to grant a local user dial-back access (see page 84). Users
Dial-back	with dial-back access can dial into the SLB branch office manager
	and enter their login and password. Once the SLB device
	authenticates them, the modem hangs up and dials them back.
	Disabled by default.
Dial-back	The phone number the modem dials back on depends on this
Number	setting for the device port. The user is either dialed back on a fixed
	number (specified on the Device Port - Settings page), or on a
	number that is associated with the user’s login (specified here).
Escape	A single character or a two-character sequence that causes the
Sequence	SLB branch office manager to leave direct (interactive) mode. (To
	leave listen mode, press any key.)
	A suggested value is Esc+A (escape key, then uppercase "A"
	performed quickly but not simultaneously). You would specify this
	value as \x1bA, which is hexadecimal (\x) character 27 (1B)
	followed by an A.
	This setting allows the user to terminate the connect direct
	command on the command line interface when the endpoint of the
	command is deviceport, tcp, or udp.
Break	A series of 1-10 characters users can enter on the command line
Sequence	interface to send a break signal to the external device. A suggested
	value is Esc+B (escape key, then uppercase “B” performed quickly
	but not simultaneously). You would specify this value as \x1bB,
	which is hexadecimal (\x) character 27 (1B) followed by a B.
Custom Menu	If custom menus have been created, you can assign a default
	custom menu to the user. The custom menu will display at login.
	Note: In the Local Users table, if the menu assigned to a local user
	no longer exists, it is marked with an asterisk (*).
Display Menu	If custom menus have been created, select to enable the menu to
at Login	display when the user logs into the CLI.
Password/	When a user logs into the SLB branch office manager, the SLB
Retype	device prompts for a password (up to 64 characters). The sysadmin
	establishes that password here.
Password
Password	If not selected, allows the user to keep a password indefinitely. If
Expires	selected the user keeps the password for a set period. (See Local
	and Remote Users on page 137 for information on specifying the
	length of time before the password expires.)
Allow	Select to allow the user to change password.
Password
Change
Change	Indicate whether the user must change the password at the next
Password on	login.
Next Login
Lock Account	Select to lock the account indefinitely.

SLB™ Branch Office Manager User Guide 140